Verilink DDS Lite (34-00295.C) Product Manual - Manual (Page 2)

ii
Copyright Notice Copyright © 2001 Verilink Corporation. All rights reserved.
This document does not create any express or implied warranty about Verilink or
about its products or services. Verilink’s sole warranty is contained in its product
warranty. The end-user documentation is shipped with Verilink’s products and
constitutes the sole specifications referred to in the product warranty. Verilink has
made reasonable efforts to verify that the information contained herein is accurate, but
Verilink assumes no responsibility for its use or for any infringement of patents or
other rights of third parties that may result. The customer is solely responsible for
verifying the suitability of Verilink’s products for its use. Specifications are subject to
change without notice.
Manual reorder # 34-00295
Revision C, October 2002
Trademarks Verilink is a registered trademark Verilink Corporation.
Any named products herein are trademarks of their respective companies.
FCC
Requirements This equipment (Multi-Rate DDS CSU/DSU) has been tested and found to comply
with the limits for a Class A digital device, pursuant to Part 15 of FCC Rules. These
limits are designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user is required to correct the interference at his
own expense. This device must also accept any interference received, including
interference that may cause undesired operation.
For use only with a certified Class 2 power supply. See Power Source in
Specifications on page 3.
Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user’s authority to
operate the equipment.
This equipment complies with Part 15 of the FCC Rules. On the rear or bottom of the
unit is a label that contains the FCC registration number and other information. If
requested, provide this information to the telephone company. Operation is subject to
the following two conditions:
✦ This device may not cause harmful interference.
✦ This device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference. The user will be
required to correct the interference at his own expense.
Notice to Users of DDS service: The following instructions are provided to ensure
compliance with FCC Rules, Part 68:
1 All direct connections to DDS lines must be made using standard plugs and jacks.
An FCC-compliant telephone cord and modular plug is provided with the
equipment. This equipment is designed to be connected to the telephone network or
premises wiring using a compatible modular jack which is Part 68 compliant.