Verilink NetPath 2000 Product Manual - Manual (Page 14)

1-4 N e t P a t h 2 0 0 0
The front panel’s power switch LED is illuminated with the unit is on.
Rear Panel
The NetPath 2000 rear panel is shown in Figure 1.4.
Figure 1.4 NetPath 2000 Rear Panel
The NetPath 2000 rear panel has three interfaces described in detail below.
NetPath 2000 Interfaces
The NetPath 2000 has the following interfaces:
Local Management Ethernet Interface
This is a direct Ethernet connection for local management and configuration.
The default IP address is 192.168.100.1, and this address is configurable.
DHCP can be configured ON or OFF for this interface.
Branch Router Ethernet Interface
This is a connection to the branch office router. The default IP address is
192.168.1.1, and this address is configurable. DHCP can be configured ON or
OFF for this interface.
PCMCIA Slot
This connection (slot) lets you use a PCMCIA wireless card.
Local
Mgmt
Router
Wireless Card Inserted into PCMCIA SLOT
Power Connector