Vinpower Digital HDDShark - Manual (Page 18)

15
7)
Size Tolerance
Normally, the capacity of the target hard drive is required to be greater than the
source hard drive so that all of the data can be copied without loss.
However, not all hard drives have identical storage capacity, even when they are
all labeled identically in terms of GB size. Thus, by enabling the size tolerance,
the system will allow the target hard drive’s capacity to be less than the original
hard drive by the percentage specified at the risk of less data loss/corruption.
6. Utilities
1)
Compare
This function will perform the data comparison process between the source and
target hard drive to ensure data accuracy.
2) Verify Disk
This function will scan all target hard drives for readability.
3)
Measure Speed
This function will perform read and write testes to report the read speed for the
source hard drive and write speed of all target hard drives.
4)
Device Info
This function will show information regarding the hard drive connected to the
system.
5) System Info
This function will show the system’s hardware & software information.
6)
Load Default
This function will reset all of the options back to the manufacture’s default
settings. Perform this function if the system is acting abnormal. Perform the
“Shutdown” operation and restart the system in order for these changes to take
effect.
7) Update Firmware
This function will update the software for the system. The update file needs to be
transferred to a Hard Drive pre-formatted as “FAT32” file system on a PC.
There are two options for this function:
 Format Update HDD: This function will prepare a hard drive to be eligible for
firmware-update by format such hard drive in the source port as FAT16/32
File System.
Setup
7.Size Tolerance