Visara FEP-4600 Installation - Manual (Page 111)

FEP-4600 Installation and Configuration
707119-001 11-1
Chapter 11. Static Gateway Circuits
Configuring Static Gateway Circuits
Static Gateway Circuits are used to tie upstream host connections to downstream device
(PU 2 and BSC) and PU 4 (FEP) connections. Dynamic Gateway Circuits do not require
configuration on this panel.
To configure the Circuits, select ‘Configure’ from the menu at the top of most panels, to
display the Configuration menu as shown below.
Press the Circuits button shown in the diagram above.