Visara FEP-4600 Installation - Manual (Page 17)

FEP-4600 Installation and Configuration
707119-001 1-9
Powering Up the FEP-4600
If you are applying an IP address, insert the floppy with the FEP4600.ini file into the
floppy drive before applying power. With one or more power cables attached to the FEP-
4600 and a power source, press the power button (button is located in the upper right
corner of the front of the platform) to apply power.
Power Button
If none of the indicators light up with the power applied, recheck the power cable
connections and check any power switches or circuit breakers associated with your power
source.
Once the power up sequence has completed (should take less than 5 minutes), you should
be ready to configure the FEP-4600 with your browser.