Watson-Marlow FF30 V2 - Manual (Page 13)

INSTRUCTION HANDBOOK
FF30 V2
FF30 IH EN 74-216-201 v1.20.doc Page 13 of 26
3.2.2 Screw cap format parts
Screw cap format parts consist of 1 single capping head. If several sizes of capping heads have been
ordered, each size is marked with one number which together with the bottle format parts composes
the customised parts for one specific bottle size. The number does not have any reference to the
bottle size; it is merely a number which is engraved in the parts to ensure that the matching parts can
be recognized. E.g. bottle format parts marked with the number 1 – match the capping head marked
with the number 1.
Mounting of capping unit
Mount the capping unit on the two steel columns Mount the two hoses for
compressed air.
Change of capping head
Hold the head with one hand And with the other hand press
the quick coupling down Pull the head down until it is
released from the coupling
When mounting another size of capping head, it is not necessary to touch the quick coupling. Just
press the head into the coupling until it clicks.