Watson-Marlow PD12I - Manual (Page 16)

INSTRUCTION HANDBOOK
PD12I / PD12P
PD12IP IH 1.03 EN Version: 1.03 Page 16 of 20
8 Cleaning and maintenance
8.1 Daily cleaning
As PD12 is not in direct contact with the dispensed product, daily cleaning will not be
necessary except for the normal routine cleaning of production equipment.
Liquids must NOT be splashed onto the PD12. It may only be cleaned with a damp paper
towel or a firmly wrung cloth.
The cabinet is made of stainless steel and anodized aluminium, and normal cleaning agents
such as tepid/medium hot water, ethyl alcohol (ethanol) 70% may be used all over the
machine.
8.2 Sterilization
If PD12 is placed in an aseptic environment, the sterilization may be made as described in
section 5.1, or you may sterilize PD12 by gases observing the following precautions.
If you use gases that might injure and corrode contacts and other metals, air slots and
sockets MUST be covered with tape.
8.3 Maintenance
As all movable parts in PD12 are maintenance-free, no maintenance is required apart from
normal cleaning of the equipment.
Should service be needed, please contact WM Flexicon A/S or your supplier.