Welltech FXSO Gateway In SIP V.1.2 - Manual (Page 92)

FXSO SIP Gateway User Manual Document Ver.: 102
Released Dec., 2004
90
1. Record ring back tone: user can use FXS Line1 to call FXO Line1,
after hearing ring back tone, use this command to detect
frequency of ring back tone.
2. Record disconnect tone: Please read the procedure of recording
disconnect tone file from the web site in application.
3. The value of disconnect tone and ring back tone will not write in
flash automatically. Please use the command in “tone” to write in
the tone table.
The Procedures of recording the disconnect tone
Before you start ：
A PSTN line which connect with the Line 1 port.
A analog phone connect with the Tel 1 port.
Configure Peer-to-Peer mode.
Please record the disconnect tone just follow the stage as below ：
1. Please enter the command before you record the disconnect tone：
record –tone
2. Make a call from PSTN side into Line 1 port.
3. You will get a greeting when the call enter the gateway.
4. Pease dial the number of the Tel 1 port.
5. The phone will ring if the number you dial is correct.
6. Pick up the phone and make sure the call is connect.
7. Hang up the phone which is from PSTN side and Tel 1 port will get the
disconnect tone.
8. When you get the disconnect tone from the phone set of the Tel 1 port,
press <R> and <ENTER> buttons to start recording the disconnect tone.
9. Please hang up the phone if you get the message as below：Analizing!!
Please wait a moment…
10. There are three values you will get after analyzing. Please leave the value
which is over 1000 Hz, this is not the frequency of disconnect tone.
11. Please put the frequency in the tone table just follow the command：
tone 4 420 680 8 8 25 25 50 50