Westermo Lynx 100 - Manual (Page 21)

21 6640-2205
Factory Reset
The factory reset option restores the switch to its original factory condition. The switch
will be restored using the following settings.
· IP address 192.168.2.200
· Subnet mask 255.255.255.0
· Gateway 192.168.2.1
· All ports are enabled
· FE ports are in auto negotiate
· FX are in 100 Mbit/s on Lxxx and Auto Negotiate on L1xxx
· All applications are disabled
· Password reset to westermo
To perform a Factory Reset follow the procedure below, read all steps before
performing. If you have any doubts wherer the reset is performed or not, do
NOT unplug the power supply, wait for confimation according to step 5.
1. Disconnect the power
2. Connect cables between port 1-6 and port 2-5.
3. Apply power
4. Wait for approx 90 seconds. (Some LED will flash during start up)
5. When the Green LED's on port 1-6 are constantly on remove the cables
connected to port 1-6 and 2-5.
6. It is now safe to remove the power and restart the switch.
7. When the switch has started up it will have the default settings.
NOTE!
If the power is removed before the factory reset has finished, the switch can be unusable.