Method 2: using the flush mount – ACTi KCM-3311 User Manual
Page 10
Advertising
Hardware Manual
Method 2: Using the Flush Mount
You can use the
PMAX-1008
flush mount to mount the camera on ceilings.
NOTE:
Due to continuous product improvements, the camera images on this documentation may
slightly differ from the actual camera that you received. Installation procedures remain the same.
Prepare the following:
PMAX-1008 Flush Mount
Drilling template
Screws (3)
Foam rubber pads (3)
Jig saw (not supplied)
Phillips screwdriver (not supplied)
To mount the camera, follow the procedures below:
1) Drill a Hole on the Ceiling
Drill a 184-mm diameter hole on the ceiling where you want to mount the camera, then route the
network cable through the hole.
Advertising