Hardware manual – ACTi KCM-3311 User Manual
Page 24
Hardware Manual
If you are using multiple devices, you need to change the current device to another unused
IP address, so that when the next device is connected to the network, no two devices use
the same IP. Please perform the following steps.
7.
Go to Network -> Connection Type
8.
Change the IP mode to Static.
9.
Change the IP to 192.168.0.101 or any other unused IPs. Do NOT use the PC
’s IP address
or 192.168.0.100.). If this is not the first device you add to the network, please also avoid
other devices
’ IPs.
10.
Click
“Apply”
11.
Please go to Maintain -> Save & Reboot, and click
”Apply”. Internet Explorer will close after
a few seconds. This is normal.
12.
Wait for 30 seconds, and open IE again to connect to the
new IP
. (In this example,
192.168.0.101). For the second device or more you add into the network, please type the
correct IP.
13.
Adjust the default Video setting by going to Video & Audio ->Video