Epic Fitness EPSY5015.0 - Manual (Page 21)

21
48. Attach the High Cable (88) and a Weight Cap
(67) to the indicated Weight Tube (75) with an
M10 x 50mm Bolt (106) and an M10 Nylon
Locknut (111).
49. Identify the Press Cable (72). Attach the Cable
to the Left Base (2) with an M8 x 25mm Shoulder
Bolt (92).
Make sure that the Cable end can
pivot easily around the shoulder of the Bolt.
50. Wrap the Press Cable (72) over a Pulley (43).
Attach the Pulley, a Cable Trap (48), an M10
Washer (109), and two Finger Guards (45) to the
Leg Press (12) with an M10 x 120mm Bolt (97)
and an M10 Nylon Locknut (111).
Make sure that
the Cable Trap is oriented to hold the Cable in
the groove of the Pulley.
51. Wrap the Press Cable (72) under a Pulley (43).
Attach the Pulley, a Cable Trap (48), an M10
Washer (109), and two Finger Guards (45) to the
Left Seat Upright (14) with an M10 x 120mm Bolt
(97) and an M10 Nylon Locknut (111).
Make sure
that the Cable Trap is oriented to hold the
Cable in the groove of the Pulley.
111
67
75
106
88
48
49
92
72
2
72
43
45
12
51
52
111
109
109
50
45
48
97
72
43
48
14
45
111
45
97
46
43
48
46
95
13
72
111
109
52. The weigth system is shown from the oppo-
site side in this step. Wrap the Press Cable (72)
under a Pulley (43). Attach the Pulley, a Cable
Trap (48), an M10 Washer (109), and two Half
Finger Guards (46) to the Press Frame (13) with
an M10 x 45mm Bolt (95) and an M10 Nylon
Locknut (111).
Make sure that the Cable Trap is
oriented to hold the Cable in the groove of the
Pulley.