Epic Fitness EPSY5015.0 - Manual (Page 22)

22
53. Wrap the Press Cable (72) under a Pulley (43).
Attach the Pulley, a Cable Trap (48), an M10
Washer (109), and two Half Finger Guards (46) to
the Left Base (2) with an M10 x 130mm Bolt
(107) and an M10 Nylon Locknut (111).
Make
sure that the Cable Trap is oriented to hold
the Cable in the groove of the Pulley.
56. Attach a Backrest (35) and a Backrest Plate (117)
to the Right Upright (7) with four M6 x 30mm
Screws (99).
54. Attach the Press Cable (72) to the Small Pulley
Plate (50) with an M6 Washer (114) and an M6
Nylon Locknut (103).
See the inset drawing. Do
not completely tighten the Nylon Locknut; it
should be tightened so that only two threads
of the Cable show past the Nylon Locknut.
111
109 107
46
46
72
48
43
2
53
54
72
50
114
103
72
99
56
99
35
117
7
103
50
Seat Assembly
55. Attach the Curl Pad (38) and the Curl Plate (120)
to the Curl Post (16) with two M6 x 30mm Screws
(99).
38
16
99
55
120