Elo TouchSystems CRT Touchmonitors - Manual (Page 11)

Chapter 2 : Installation
6 - Elo Entuitive Touchmonitor CRT User Guide
2. Connect the power cord to the AC connector on your touchmon-
itor. To protect your equipment against risk of damage from
electrical surges in the power line, plug the touchmonitor’s
power cord into a surge protector, and then connect the surge
protector to a grounded (three-pronged) AC electrical outlet.
3. Connect the touchscreen cable. Determine if you have RS-232
or USB. Connect one end to the appropriate port on the back of
your PC. Connect the other end of the cable to the touchscreen
connector on your touchmonitor. The touchscreen cable connec-
tors should fit snugly into the connectors on your touchmonitor
and PC.
4. Power on your PC then power on your monitor. After a brief
pause the picture should appear.
5. If necessary, adjust the front panel controls according to your
personal preference (see Chapter 3).
6. Insert the Elo TouchTools CD-ROM in your computer’s CD-
ROM drive to install the appropriate touchscreen driver soft-
ware.