Alinco DJ-V57 - Manual (Page 34)

5.Useful Functions
5
34
5.1.3 Setting Skip Channels
You can select the memory channels that you wish to skip during the memory-scan.
• Press the FUNC key in the Memory mode, and while is displayed, press the
key to set the currently selected memory channel as a skip channel.
Use the same procedure to clear the skip channel setting.
• The 10MHz decimal point appears for memory channels that are set as skip
channels.
Press the FUNC key, and while is displayed, press the key to set the Keylock
function on, and repeat the same to quit.
When the Keylock is on, the is displayed on the LCD.
When the Keylock is on, other than the following, all operations are blocked.
* PTT * LAMP * MONI * VOL * SQL * Tone-burst
* POWER ON/OFF * DTMF tone * VOX sensitivity
This function is to generate an audible tone to access European repeaters.
• To output the tone-burst tone, press the MONI key while holding down the PTT key.
The tone is transmitted as long as the MONI key is pressed.
The initial setting for the tone-burst tone is 1750Hz, but this can be changed in the
Set mode (page 49).
• While transmitting the tone-burst tone, the CTCSS/DCS tone is temporary
suspended.
• The transmitting tone can't be monitored.
Tone-Burst 5.3
NOTE:
Keylock function can't be activated on the Repeater-Access function memory
setting channel.
Keylock 5.2
NOTE:
The Call channel and Repeater-Access memory are automatically skipped
during scanning.