Amer Networks WAP33DC - Manual (Page 9)

WAP3xDC Series Wireless Indoor AP
Installation Manual Chapter 3 AP Installation
3.4.1 Wall Hanging Installation
Use the wall mounting bracket and the supporting expansion bolts and screws if you plan
to install the device to a wall.
Fig 3-2 wall mounting bracket size and block diagram (unit: mm)
If you choose to install the AP using the wall hanging method, we recommend connecting
the Ethernet cable to the AP first and then install the AP to the wall mounting bracket.
(1) Connect the AP to the POE port by using the cable
Place the mounting kit flat against the wall and mark the holes where the screws are
going to be. Punch four holes using an impact drill.
Insert the expansion bolt into the holes and use a hammer it down until the bolt
completely goes into the wall.
3-3