Eneo HDD-2030PTZ1080 - Manual (Page 17)

3.5 Preset (Shortcut: PRST)
If you need to view specific places routinely, you should program Presets. A Preset is a
programmed video scene with automatic pan, tilt, zoom, focus, and AE settings. Once
programmed, placing the number position and pressing the PRST key on your controller calls up
that Preset automatically. In addition, Presets may be assigned the “home” position for the dome
camera. As many as 240 Presets, whose positions are saved in the dome’s firmware, may be
programmed.
There are eight pages of Preset menu. Each page has 30 Presets. Pages can be scrolled by
pushing the Joystick to the left or right on the first or last No. of Preset.
PRESET SETUP
NUMBER : 001
TITLE : ------
CAMERA SET
DWELL : -- SEC
1 2 3 4 5 6 7 8 9 0
- * - - - - - - - -
- - - - - - - - - -
- - - - - - - - - -
NEXT PAGE
SAVE AND EXIT(ESC TO CANCEL)
- Blank Preset position
* Position has the Preset
! Current cursor position
Follow steps below to store the Preset positions:
1. Press the PRST key to enter the Preset menu directly. Or press the MENU key to display the
main menu on the monitor. Scroll to Preset and push the Joystick to the right.
2. Select the blank Preset position to be stored by pushing the Joystick up, down, right, or left.
3. After selecting a blank position, press and hold the CTRL key. Use the Joystick to control the
direction of the camera and lens.
4. After aiming the camera (view direction and lens control), release the CTRL key. The cursor will
be on the “TITLE” after saving data then twist the Joystick or press the Tele or Wide key to
edit the Preset title. Follow the procedure of the Auto Scan above to edit titles.
5. Select “CAMERA SET” and push the Joystick to the left or right. Then the Preset camera setup
displays.
PRESET CAMERA SETUP
FOCUS : AUTO
AE SETUP
SAVE AND EXIT(ESC TO CANCEL)
Set FOCUS AUTO, MANUAL, ONE PUSH
12