H3C Technologies H3C S12500 Series Switches - Manual (Page 195)

182
[DeviceA-vlan2] quit
2. Configure Device B:
# Enable GVRP globally.
<DeviceB> system-view
[DeviceB] gvrp
# Configure port GigabitEthernet 3/0/1 as a trunk port, and assign it to all VLANs.
[DeviceB] interface GigabitEthernet 3/0/1
[DeviceB-GigabitEthernet3/0/1] port link-type trunk
[DeviceB-GigabitEthernet3/0/1] port trunk permit vlan all
# Enable GVRP on GigabitEthernet 3/0/1, and set the GVRP registration mode to forbidden on
the port.
[DeviceB-GigabitEthernet3/0/1] gvrp
[DeviceB-GigabitEthernet3/0/1] gvrp registration forbidden
[DeviceB-GigabitEthernet3/0/1] quit
# Create VLAN 3 (a static VLAN).
[DeviceB] vlan 3
[DeviceB-vlan3] quit
Verifying the configuration
Use the display gvrp local-vlan command to display the local VLAN information maintained by GVRP on
ports. For example:
# Display the local VLAN information maintained by GVRP on port GigabitEthernet 3/0/1 of Device A.
[DeviceA] display gvrp local-vlan interface GigabitEthernet 3/0/1
Following VLANs exist in GVRP local database:
1(default)
The output shows that information about VLAN 1 is registered through GVRP, but static VLAN information
of VLAN 2 on the local device and dynamic VLAN information of VLAN 3 on Device B are not.
# Display the local VLAN information maintained by GVRP on port GigabitEthernet 3/0/1 of Device B.
[DeviceB] display gvrp local-vlan interface GigabitEthernet 3/0/1
Following VLANs exist in GVRP local database:
1(default)
The output shows that information about VLAN 1 is registered through GVRP, but static VLAN information
of VLAN 3 on the local device and dynamic VLAN information of VLAN 2 on Device A are not.