H3C Technologies H3C S12500 Series Switches - Manual (Page 264)

251
Use the display mvrp running-status command to display the local MVRP VLAN information to
verify whether the configuration takes effect.
# Check the local VLAN information on GigabitEthernet 3/0/1 of Device A.
[DeviceA] display mvrp running-status
-------[MVRP Global Info]-------
Global Status : Enabled
Compliance-GVRP : False
----[GigabitEthernet3/0/1] ----
Config Status : Enabled
Running Status : Enabled
Join Timer : 20 (centiseconds)
Leave Timer : 60 (centiseconds)
Periodic Timer : 100 (centiseconds)
LeaveAll Timer : 1000 (centiseconds)
Registration Type : Normal
Local VLANs :
1(default), 3,
The output shows that GigabitEthernet 3/0/1 has learned VLAN 1 and dynamic VLAN 3 created
on Device B through MVRP.
# Check the local VLAN information on GigabitEthernet 3/0/1 of Device B.
[DeviceB] display mvrp running-status
-------[MVRP Global Info]-------
Global Status : Enabled
Compliance-GVRP : False
----[GigabitEthernet3/0/1] ----
Config Status : Enabled
Running Status : Enabled
Join Timer : 20 (centiseconds)
Leave Timer : 60 (centiseconds)
Periodic Timer : 100 (centiseconds)
LeaveAll Timer : 1000 (centiseconds)
Registration Type : Normal
Local VLANs :
1(default), 2,
The output shows that GigabitEthernet 3/0/1 has learned VLAN 1 and dynamic VLAN 2 created
on Device A through MVRP.
4. Set the MVRP registration mode to fixed on GigabitEthernet 3/0/1 of Device B:
# Set the MVRP registration mode to fixed on GigabitEthernet 3/0/1.
[DeviceB] interface GigabitEthernet 3/0/1
[DeviceB-GigabitEthernet3/0/1] mvrp registration fixed
[DeviceB-GigabitEthernet3/0/1] quit
# Check the local VLAN information on GigabitEthernet 3/0/1 of Device B.
[DeviceB] display mvrp running-status
-------[MVRP Global Info]-------
Global Status : Enabled