H3C Technologies H3C S6300 Series Switches - Manual (Page 272)

259
Operation Description XML example
edit-config:
default-operation
Modifies the current
configuration of the device
using the default operation
method.
If you do not specify an
operation attribute for an
edit-config message, NETCONF
uses one of the following default
operation attributes: merge,
create, delete, and replace.
Your setting of the value for the
<default-operation> element
takes effect only once. If you do
not specify an operation
attribute and the default
operation method for an
<edit-config> message, merge
is always applied.
• merge—This is the default
value for the
<default-operation>
element.
• replace—This value is used
when the operation attribute
is not specified and the
default operation method is
specified as replace.
• none—This value is used
when the operation attribute
is not specified and the
default operation method is
specified as none. If this
value is specified, the
edit-config operation is used
only for schema verification
rather than issuing a
configuration. If the schema
verification is passed, a
successful message is
returned. Otherwise, an
error message is returned.
To issue an empty operation for schema verification
purposes:
<rpc message-id ="101"
xmlns="urn:ietf:params:xml:ns:netconf:ba
se:1.0">
<edit-config>
<target>
<running/>
</target>
<default-operation>none</default-operati
on>
<config
xmlns:xc="urn:ietf:params:xml:ns:netconf
:base:1.0">
<top
xmlns="http://www.h3c.com/netconf/config
:1.0">
<Ifmgr>
<Interfaces>
<Interface>
<Index>262</Index>
<Description>222222</Description>
</Interface>
</Interfaces>
</Ifmgr>
</top>
</config>
</edit-config>
</rpc>