H3C Technologies H3C S6300 Series Switches - Manual (Page 92)

79
Step Command Remarks
8. (Optional.) Set the lowest level
of logs that can be output to
the monitor terminal.
terminal logging level severity
The default setting is 6
(informational).
Outputting logs to a log host
Step Command Remarks
1. Enter system view. system-view N/A
2. Enable the information
center.
info-center enable
By default, the information center is
enabled.
3. Configure an output rule
for outputting logs to a
log host.
info-center source { module-name |
default } { console | monitor |
logbuffer | logfile | loghost } { deny
| level severity }
For information about default output
rules, see "
Default output rules for
logs ."
4. (Optional.) Specify the
source IP address for
output logs.
info-center loghost source
interface-type interface-number
By default, the source IP address of
output log information is the primary IP
address of the matching route's egress
interface.
5. (Optional.) Specify the
format for logs sent to a
log host. info-center format { unicom | cmcc }
By default, logs are sent in H3C format
to a log host.
6. (Optional.) Configure
the timestamp format.
info-center timestamp loghost { date
| iso | no-year-date
[ with-timezone ] | none }
By default, the timestamp format is
date.
The with-timezone keyword is
available in Release 2311P03 and
later versions.
7. Specify a log host and
configure related
parameters.
info-center loghost { loghost | ipv6
loghost } [ port port-number ]
[ facility local-number ]
By default, no log host or related
parameters are specified.
The value of the port-number argument
must be the same as the value
configured on the log host. Otherwise,
the log host cannot receive logs.
Outputting logs to the log buffer
Step Command Remarks
1. Enter system view. system-view N/A
2. Enable the information center. info-center enable
By default, the information center is
enabled.
3. Enable log output to the log
buffer.
info-center logbuffer
By default, log output to the log
buffer is enabled.