H3C Technologies H3C S5120 Series Switches - Manual (Page 63)

55
CAUTION:
•
The PC and the TFTP/FTP server can be the same device.
• The TFTP/FTP server program is not provided with the S5120-SI Switch Series. Make sure that it is
available by yourself.
2. Run the TFTP Server program on the sever
Run TFTP Server on the server connected with the switch’s Ethernet port, and specify the path of the boot
file to be downloaded.
3. Run the terminal emulation program on the PC connected with the switch’s console port. Start the
switch and enter the Boot ROM menu. Then enter the protocol parameter setting menu.
To load the Boot ROM file, enter 6 in the Boot ROM menu after the system displays “Enter your
choice(0-9):” to enter the Boot ROM update menu.
1. Update full BootRom
2. Update extended BootRom
3. Update basic BootRom
0. Return to boot menu
Enter your choice(0-3):
4. Enter the protocol parameter setting menu
Enter 1 to upgrade the complete Boot ROM file, and then enter the protocol parameter setting menu.
Bootrom update menu:
1. Set TFTP protocol parameter
2. Set FTP protocol parameter
3. Set XMODEM protocol parameter
0. Return to boot menu
Enter your choice(0-3):
5. Configure the switch to upload the Boot ROM file through TFTP
Enter 1 to upgrade the Boot ROM file by using TFTP, and then set the TFTP parameters.
Load File Name :update.bin
Server IP Address :10.10.10.2
Local IP Address :10.10.10.3
Gateway IP Address :
Table 20 Description of the TFTP parameters
Item Description
Load File Name : Name of the file to be downloaded (for example, update.bin)
Server IP Address : IP address of server (for example, 10.10.10.2)
Local IP Address : IP address of the switch (for example, 10.10.10.3)
Gateway IP Address : IP address of the gateway (suppose it is not specified)