H3C Technologies H3C MSR 50 - Manual (Page 23)

16
Task Command Remarks
View the ACSEI client version. rpm -q acsei-client -i N/A
The rpm commands are Linux commands. For more information, see Linux operating system guides.
Changing the default startup setting for the ACSEI client
The ACSEI client is enabled automatically after it is installed, and by default, the ACSEI client starts up
when the OAP module starts up. You can configure the system to start or not to start the ACSEI client with
the startup of the OAP module through either the CLI or GUI of the Linux operating system.
To change the default startup setting for the ACSEI client at the CLI, use one of the following commands
in the Linux system on the OAP module:
Task Command Remarks
Configure Linux not to start the ACSEI
client automatically at startup.
chkconfig acseid off
By default, the ACSEI client is
automatically started at startup.
Configure Linux to start the ACSEI
client automatically at startup.
chkconfig acseid on
By default, the ACSEI client is
automatically started at startup.
To change the default startup setting through the GUI:
1. Log in to the Linux system on an OAP module, and then run the setup command in the Linux system.
Figure 3 Setup interface for the ACSEI client default startup
2. Select System services and press the Enter key.