H3C Technologies H3C SecPath F5000-A5 Firewall - Manual (Page 79)

69
To configure the exception handling method:
Step Command Remarks
Enter system view. system-view N/A
Configure the exception handling
method for the MPU.
system-failure { maintain | reboot }
Optional.
By default, the MPU uses the reboot
method when an exception occurs.
NOTE:
Rebooting an MPU reboots the firewall.
Displaying the exception handling method
Use the display system-failure command to display the exception handling method.
<Sysname> display system-failure
System failure handling method: reboot
Rebooting your firewall
You can reboot the firewall in one of the following ways to recover from an error condition:
• Reboot the firewall immediately at the command line interface (CLI).
• At the CLI, schedule a reboot to occur at a specific time and date or after a delay.
• Power off and then re-power on the firewall. This method, also known as hardware reboot or cold
reboot, might cause data loss, and is the least preferred method.
IMPORTANT:
•
Specify the boot file before you use the reboot command to reboot the firewall.
• For data security, if you are performing file operations at the reboot time, the system does not reboot.
The precision of the rebooting timer is 1 minute. One minute before the rebooting time, the firewall
prompts "REBOOT IN ONE MINUTE" and reboots in one minute.
To reboot a firewall:
Task Command Remarks
Reboot a card or the whole
system immediately.
reboot
Optional.
Available in user view.
Enable the scheduled reboot
function and specify a specific
reboot time and date.
schedule reboot at hh:mm [ date ]
Optional.
The scheduled reboot function is
disabled by default.
Available in user view.