H3C Technologies H3C SecPath F5000-S Firewall - Manual (Page 45)

36
Item Description
HTTPS
Specify whether to enable HTTPS on the device, and set the HTTPS port number.
Disabled by default.
IMPORTANT:
• If the current user logged in to the Web interface through HTTPS, disabling HTTPS
or modifying the HTTPS port number will result in disconnection with the device.
Therefore, perform the operation with caution.
• When you modify a port number, make sure the port number is not used by
another service.
• By default, HTTPS uses the PKI domain default. If this PKI domain does not exist, the
system will prompt you for it when the configuration wizard is completed. However,
this does not affect the execution of other configurations.
7. Click Next.
The page for configuring interface IP appears.
The table lists the IP address configuration information for all Layer 3 Ethernet interfaces and VLAN
interfaces. You can click a value in the table and then modify it.
You can configure an IP address and mask only when you select Static Address for IP
Configuration.
Figure 31 Basic configuration wizard—4/6 (interface IP address configuration)
8. Assign IP addresses to the interfaces.