Set output source – Grass Valley 8943RDA User Manual
Page 36
36
8943RDA/-D/-DFR — Instruction Manual
Configuration
Set OUTPUT SOURCE
Input to output mapping is done by choosing an input channel to feed an
output coax pair or an optional fiber output (8943RDA-DFR only). This
setting is only done on the 8943RDA-D and the 8943RDA-DFR models.
Refer to
for the factory default settings. The 8943RDA
has only one input which is automatically mapped to all output pairs.
Output mapping is summarized in
Input to Output Mapping on page 32
To assign a source to an output, do the following:
1.
J1-2 SOURCE
: Rotate the Function rotary switch to position
5
to select the
input source to feed output coax pair J1/J2 from one of the following
sources:
•
CH1 (Coax J9 for 8943RDA/-D or Coax J10 for 8943RDA-DFR)
•
CH2 (Coax J10 for 8943RDA-D or Coax J8 for 8943RDA-DFR)
•
CH3 (Fiber 1 input available when Dual Receiver SFP fiber optic
option is installed on 8943RDA-DFR only)
•
CH4 (Fiber 2 input available when Dual Receiver or Transceiver
SFP fiber optic option installed on 8943RDA-DFR only)
Use the paddle switch to move between channel choices, the OUTPUT
SOURCE LEDs will light indicating which channel is selected. Move
through the channels until the LED is highlighted for the input source
you want to feed J1-2 coax output pair.
2.
J3-4 SOURCE
: Set the Function rotary switch to
6
to select the input source
to feed output coax pair J3-4 in the same manner as Step 1 above.
3.
J5-6 SOURCE
: Set the Function rotary switch to
7
to select the input source
to feed output coax pair J5-6 in the same manner as Step 1 above.
4.
J7-8 SOURCE
: Set the Function rotary switch to
8
to select the input source
to feed output coax pair J7-8 (8943RDA-D) or J7 (8943RDA-DFR only)
in the same manner as Step 1 above.
5.
FIBER1 SOURCE (8943RDA-DFR only)
: Set the Function rotary switch to
9
to
select the input source to feed the optional Fiber 1 output in the same
manner as Step 1 above. For Fiber 1 output presence, an optional dual
transmitter fiber submodule must be installed on the 8943RDA-DFR
front module and jumper J13 must be set to enable the transmitter
outputs (pins 2-3).
6.
FIBER2 SOURCE (8943RDA-DFR only)
: Set the Function rotary switch to
A
to
select the input source to feed the optional Fiber 2 output
(8943RDA-DFR only) in the same manner as Step 1 above. For Fiber 2
output presence, an optional dual transmitter fiber submodule or a
transceiver fiber optic submodule (Fiber 1 input/Fiber 2 output) must
be installed on the 8943RDA-DFR front module and jumper J13 must be
set to enable the transmitter outputs (pins 2-3).