Grass Valley 8964DEC v.1.0.5 - Manual (Page 26)

26 8964DEC/-FS Instruction Manual
Configuration
Remote Configuration and Monitoring
8964DEC configuration and monitoring can be performed using a web
browser GUI interface or the Newton Control System when the 8900NET
Network Interface module is present in the frame (Gecko 8900TFN frame).
This section describes the GUI access to the module configuration func-
tions. For information on using the Newton Control Panels, refer to
Newton
Control Panel Configuration on page 51 .
For remote access, make sure the jumper block on the module is set for both
Local and Remote access (
Figure 6 on page 22 ).
Refer to the 8900NET Network Interface Module Instruction Manual for
information on the 8900NET Network Interface module and setting up and
operating the Gecko 8900 frame network.
Note The 8900NET module in the frame must be running software version 3.2.0 or
higher for proper remote and control panel operation. Upgrade software and
instructions for the 8900NET are available on a separate CD-ROM with the
module or can be downloaded from the Grass Valley web site.
Refer to the Frame Status web page shown in Figure 7 on page 27 . The 8900
modules can be addressed by clicking either on a specific module icon in
the frame status display or on a module name or slot number in the link list
on the left.
Note The physical appearance of the menu displays on the web pages shown in
this manual represent the use of a particular platform, browser and version
of 8900NET module software. They are provided for reference only. Displays
will differ depending on the type of platform and browser you are using and
the version of the 8900NET software installed in your system. This manual
reflects the 8900NET software version 3.2.2.
Use the Refresh button to update the display (available with 8900NET soft-
ware version 3.2.0 and later).
For information on status and fault monitoring and reporting shown on the
Status web page, refer to
Status Monitoring on page 55 .