Grass Valley 3-CCD CameraMan Rev.C - Manual (Page 24)

Chapter 2
18 CameraMan 3-CCD Presenter Camera System Installation and Operations
Tracking Ring Power Pack Assembly
Now you’re ready to assemble the Tracking Ring
Package and learn how to wear it properly to ensure
that your CameraMan camera follows you around
the room.
Tracking Ring Power
Pack Assembly Using the Power Pack Pouch, attach the Tracking
Power Pack directly to your clothing by clipping it to
your waistline or skirt, or to the Tracking Ring Power
Pack Belt.
The Tracking Power Pack must be worn so the
antenna hangs loosely, like shown below. Do not
place the Power Pack in your pocket. This interferes
with the RF signal and may affect the audio and
tracking capability.
FIGURE 2.4 Antenna Hanging Loosely
Tracking Ring Sensors
1. Identify the sensors:
Front Sensor: equipped with a built-in micro-
phone and tracking sensor. It is identified by the
main connector to the Power Pack.
Back Sensor: equipped with the built-in tracking
sensor only.
2. Slip the Tracking Ring around your neck.
3. Clip the Tracking Ring strap closed to form a
complete circle around your neck.
4. Verify that the Front Sensor is lying flat and cen-
tered just above chest level, and the back sensor
is lying flat on the back of your collar.
5. Plug the main connector into the port on the top
of the Tracking Ring Power Pack.