Grass Valley 3-CCD CameraMan Rev.C - Manual (Page 59)

CameraMan 3-CCD Presenter Camera System Installation and Operations Manual 53
Troubleshooting
2. Verify that the appropriate video connection is
being used on the back of the Main Docking Sta-
tion, either S-VIDEO or COMPOSITE VIDEO
OUT. (see “Main Docking Station” on page 3)
3. Verify a solid connection of the CameraMan
Cable to both the Main Docking Station and the
autoTRACK Camera.
Problem
No communications through the RS-232 port.
Solution
1. Verify that the cable being used is wired cor-
rectly.
2. Verify that the PROTOCOL SELECT switch
(Switch Bank B- Switch 1) and the Baud rate
(9600 or 19,200) (Switch bank A-7) on the back
of the autoTRACK Camera is set properly.
3. Does the COM LED next to the RS-232 port on
the back of the Main Docking Station blink when
you send a command through this port?
• If not, change the cable and retry.