Grass Valley 3430AP CopperHead - Manual (Page 44)

32
Installation and Connection
ronment IP network.
12 VBS Out
BNC Connector -Typically used for SD Monitoring Video return from the Camera
13 VBS In
BNC Connector – Typically used to send SD return video to the camera – an example is
monitor out from the production switcher. Also used for Prompter feed.
14 SDI Out 1 & 2 (this carries the HD feed (not the 3D/Dual Link) from the camera)
N/A in 3430AP configuration.
15 SDI In
BNC Connector – Typically used to send HD return video to the camera – an example is pro-
gram out from the Production Switcher
16 SDI Out A & B (this carries the dual 3D/Dual Link signals from the camera)
BNC Connectors
17 Audio In ‐ Multi‐Pin Connector
DB25 – 25 pin Connector follows the Tascam TDIF standard. The CopperHead 3430AP
Transceiver System accommodates up to two Audio Channels at Line Level. This connector
handles return audio to the Camera location as well as intercom Program Audio. Please see
Page 93 for sample wiring.
18 Audio Out ‐ Multi‐Pin Connector
DB25 – 25 pin Connector follows the Tascam TDIF standard. The CopperHead 3430AP
Transceiver System accommodates up to two Audio Channels at Line Level. This con-
nector handles return audio to the Camera location. Please see Page 94 for sample wiring.
19 & 20 Intercom Connectors #1 & #2
XLR 3 pin or 5 pin Connector depending on configuration. One of three options will be
installed (4-wire intercom, RTS or Clear-Com). Please see Chapter 6 for information on using
each of the Intercom Options.
22 12V Termiinal Block
Terminal Block – bare wire connector. This can be used in place of the ADAP power connec-
tion in installations that have 12V power distributed as part of their infrastructure. Do not
use this at the same time as the ADAP power connection.
23 12V Terminal Block
Terminal Block – bare wire connector. This can be used in place of the ADAP power con-
nection in installations that have 12V power distributed as part of their infrastructure. Do
not use this at the same time as the ADAP power connection (21).