Grass Valley Ignite SDC - Manual (Page 109)

Ignite SDC/HDC Robotic Camera Instruction Manual 109
Setting Soft Stops
Setting Soft Stops
Soft stops are software adjustable electrical limits for pan and tilt rotation.
• The default soft stops for both pan and tilt are ± 178º.
• If you install a prompter, you must set the tilt soft stops to ± 30º.
• You may also have to change default pan/tilt soft stops to prevent the
camera and/or prompter from contacting an obstacle near the selected
mounting location.
• To change the default soft stops, refer to the JSC-2300 SHOT Director
Robotics/Camera Controller Instruction Manual for procedures.
Specifications
Robotic (pan/tilt head) specifications are listed in Table 57 .
Table 57. Robotics Specifications
Pan Range ± 178º
Tilt Range ± 178º
Tilt Range w/ Prompter ± 30º
Pan and Tilt Speed 90º/s
Acceleration 360º/s
Accuracy - Repeatability
30 arc seconds
(0.1” at 60’) (1.4mm at 10m)
Maximum Load Capacity 75.0 lbs. (35 kg)
Noise Rating (@ 30º/s) <30 dBm @ 1m
Control Ethernet (10 Base-T)
Control Distance Unlimited
Control Outputs 4 (TTL)
Power 120/240, 50/60 Hz, 100 W
Weight 20 lbs (9 kg)