Grass Valley Ignite SDC User Manual
Page 35
Ignite SDC/HDC Robotic Camera Instruction Manual
35
Operating Procedure
Note
The HDC camera accepts SD and HD synchronizing signals. HD synchro-
nizing signals may require different test equipment and may display differ-
ently than signals shown in
.
•
Using a two-channel oscilloscope, observe the gen-lock input
and camera video output waveforms.
•
Match the horizontal phases of the gen-lock in and video out
signals (
), by adjusting the camera H-Phase setting of
the GEN-LOCK or G/L menu.
Figure 15. Gen-Lock Horizontal Phase Adjustment Waveform
3.
Adjust the lighting for the object.
4.
Start shooting.
•
Refer to the Ignite Live Production Control System User Manual for
automated camera control procedures.
•
Refer to the JSC-2300 SHOT Director Robotics/Camera Controller
Instruction Manual if you want to:
•
Control the camera manually
•
Create and save presets
•
Change camera settings
5.
After shooting, turn off all equipment power.
Video signal
Gen-lock signal
Horizontal phase
8492_71_r0