Grass Valley NV9607 v.1.1 - Manual (Page 38)

28
Configuration
Multi-Destination Configuration
Multi-Destination Configuration
Multi-destination configuration is a special case: it demands the creation of groups (or clusters)
of buttons on the panel. The other modes do not need this kind of grouping.
A panel configured in multi-destination mode has source buttons that represent 2 sources and a
destionation. (A source shift button switches between the two sources of the source buttons.)
Pressing a source button selects the source and the destination. If the panel is not in source
preview mode, the button performs an immediate take
— to the destination assigned to the
source button. In source preview mode, pressing a ‘Take’ button is required to complete the
take.
Source/
Destination X The button selects both a source and a destination and performs an
immediate take.
 Source/dest buttons are not subject to source preview mode. In
fact they become inactive in source preview mode.
 Source/dest buttons are not subject to source shift or destination
shift.
Source
Preview All The button toggles ‘source preview’ mode. When source preview
mode is off, pressing a source button results in an immediate take.
When source preview mode is on, pressing a source button does not
cause an immediate take, but places source information in the
‘Preview’ column of the display. Pressing a take button is required to
complete the take. This mode allows operators to preview a source
before actually executing the take.
 In source preview mode, all buttons except source buttons, source-
related buttons, the ‘Source Preview’ button and the ‘Take’ button
are disabled.
Source Shift All The button toggles between the first and second source sets.
The button definition has no fields to configure.
The button affects the operation of any source button (in any mode).
Source buttons represent two sources. One belongs to one source set
and the other belongs to the other source set.
Take All This button performs a take when a panel is in source preview mode
(i.e., it has a ‘Source Preview’ button and it is high-tally).
When the panel is not in source preview mode, any take button is
disabled and dark.
When the panel is in source preview mode, the take button is dark
until you select a source. Then the take button turns low-tally red.
After you press the take button, the button goes dark again.
Undefined All This button type is a placeholder: during configuration, it makes the
button undefined and inactive. On the actual panel, the undefined
button remains inactive and unlit (dark).
Type Modes Description