Grass Valley Profile Family 18GB Disk Drive Upgrade - Manual (Page 19)

Removing the Top-Front Cover
18GB Disk Drive Upgrade 19
Removing the Top-Front Cover
Use the following procedure to remove the top-front chassis cover:
1. Confirm that the Profile system power is switched off and the power cord is
removed.
2. Use the Torx tool with the T10 tip to remove the top screws from the front
chassis cover as shown in Figure 1, then use the T15 tip to remove the
pan-headed screws from the side of the chassis. Remove the top-front cover.
NOTE: Take care not to lose the chassis screws—they are required to meet
EMI specifications for the Profile system. Your system may contain more or
less screws in the front panel than shown in Figure 1 depending on how
many disk drives are installed.
Figure 1. Removing the Top-Front Cover
0563-5