Grass Valley Profile Family 18GB Disk Drive Upgrade - Manual (Page 32)

Installing the SCSI Cable and Disk Drives
32 18GB Disk Drive Upgrade
2. Remove the adhesive backing on the cable clamp and attach it to the top of
the power supply parallel to and adjacent to the existing clamp.
3. Connect one end of the SCSI cable to the unused connector on the SCSI
backplane (
Ê in Figure 8).
Figure 8. SCSI Cable Installation in a Profile System Without a Slave EDR Board
4. Position the cable in the clamp so that both SCSI cables are parallel.
5. Connect the free end of the cable to the top-front SCSI header connector of
the Master EDR board (
Ë in Figure 8).
6. Dress the SCSI cables through the channel at the right of the fan carrier tray.
7. Now that you have installed the SCSI cable, proceed to “Installing Disk
Drives” on page 36.
0563-1
2
1