Edelbrock 2001 PT Cruiser - Manual (Page 2)

©2001 Edelbrock Corporation
Rev. 3/01
Qty. Part No. Description Qty. Part No. Description
1 25-5519 Muffler 1 25-3180 Tailpipe
1 25-3178 Over axle pipe 1 25-3181 Tailpipe
1 25-3179 Muffler crossover pipe 1 22-5759 Instruction kit
1 23-4038 Hanger clamp assembly
PARTS LIST
WARNING: Exhaust gas contains carbon monoxide, a deadly invisible gas. Correct any leaks
ASSEMBLY (Continued)
8. Place clamp hanger assembly #23-4038 on to the left muffler outlet and slip hanger bar into the rear OEM
rubber hanger, slide left tail pipe in to the muffler outlet. Long arm of hanger goes toward rear of vehicle.
over right muffler outlet and install right tailpipe. Position the system in the cut outs in the
9. Slide OEM hanger assembly removed earlier on to the left tailpipe hanger assembly (see figure 2). Punch
holes for sheet metal screws and screw in the OEM hanger assembly with OEM sheet metal screws. Hole
an drilled so as to reduce chance that screws will work loose.
10. Centering of the whole system can be done at both the over axle and the muffler crossover pipe. Center
tailpipes in the cut outs in the valance, using the hanger strap on the right side in fr
adjust so tailpipes extend equally on both sides. Height and amount of total extension for the tailpipes can
be adjusted by tilting the muffler. When system has been adjusted for position, check system for
sion, brake lines, fuel lines, and floor pan. When system is positioned
11. Open up ground strap eyelet end to 3/8 diameter and using supplied 3/8 nut. Install onto hanger clamp
Edelbrock Corporation
2700 California St.
Torrance, CA 90503
Tech Line: (800) 416-8628
E-Mail: [email protected]