Epson 7800P - Manual (Page 14)

EPSON PowerLite 7800p Projector
5/03 EPSON PowerLite 7800p Projector - 13
Managing Projectors from a Remote
Computer
The EasyManagement software lets you monitor and control
projector(s) from a remote computer. These features are
intended for use by network administrators.
❏ Use EMP Monitor to see your projectors’ status, switch
image sources, and control basic settings.
❏ Use EMP NetworkManager to receive e-mail notifications
alerting you to possible problems.
❏ Use a network management utility running SNMP, such as
HP OpenView, ™ to manage your facility’s equipment from
a pre-existing system.
Note: A plug-in is available to allow you to manage your
projectors in HP OpenView. Additionally, other SNMP
management utilities may be available in the future. Check with
EPSON for availability.
Make sure you have installed the software (included on the
projector’s CD-ROM) on the computer you want to use to
monitor your projectors. (See the User’s Guide for
instructions.)
Setting Up the Network
Connect each projector you want to monitor to your network
and configure it with an appropriate IP address.
1. Connect the projector to your network using a
commercially available 100baseTX or 10baseT network
cable. Plug the cable into the projector’s Ethernet port.
2. Turn on the projector.
3. Press the Menu button on the remote control and select
Network from the Advanced2 menu.
4. If your network assigns addresses automatically, turn on
DHCP .
5. If your network does not assign addresses automatically,
turn off DHCP and enter the projector’s IP Address ,
Subnet Mask , and Gateway Address , as needed.
❏ To enter numbers using the remote control, press the
Num button until it lights, then use the numeric
keypad.
❏ To change the network addresses from the projector’s
control panel, press the right and left arrow buttons to
select the part of the address you want to enter, then
use the up and down arrow buttons to increase or
decrease the numeric value.
Note: If you’re a network administrator, you can use the
SNMP option to enter a trap IP address. This lets you receive
trap alerts for the projectors you’re monitoring. If you have
HP OpenView, a plug-in is available to allow you to manage
your projectors in HP OpenView. Check with your dealer or
EPSON.
To network port
Ethernet port
Br Brightness Control ightness Control High High Low : Video
Audio
Setting
User's Logo
Advanced1
About
Reset All
Projector ID Projector ID
Netw Network
Reset Reset Ex Execute ecute
: 1
[Menu]: Exit [ ]: Enter [ ]: Select
Effect
Advanced2
COM P COM Port
BNC Sync BNC Sync Ter ermination mination
:
ON ON OFF OFF :
Set Set
Set Set
RS-232C RS-232C USB USB
Auto setup uto setup ON ON OFF OFF :
Select
Network
Num button
Zero
Increase or
decrease
the value
Select the part of the
address to change