Epson 7800P - Manual (Page 15)

EPSON PowerLite 7800p Projector
14 - EPSON PowerLite 7800p Projector 5/03
When you finish changing an address in the network menu,
press the
Enter button (on the remote control) or the
Auto/Enter button (on the projector). This stores the
value.
6. When you’re done making all necessary changes, press ESC
to exit the menu system.
Opening and Closing EMP Monitor
To start EMP Monitor, click Start > Programs or All
Programs > EPSON Projector > EMP Monitor .
If you’ve added the program to the Startup programs folder, it
may already be open. If so, click the icon in the system tray on
the lower-right corner of your screen to display the EMP
Monitor window:
To close EMP Monitor, right-click the program icon shown
above, then select
Exit .
Registering Projectors in EMP Monitor
Before you can monitor a projector, you have to register it.
Follow these steps:
1. Open EMP Monitor. You see this screen:
2. Click Register projector . You see this screen:
3. Click Auto detect to locate projectors currently operating
on the network. Or click Manual registration and enter
the projector’s name and network address.
Note: If Auto detect fails to find the projector, your projector
may not be connected or configured correctly for the network.
Any projectors found on the network are listed:
4. Select each projector you want to add by clicking its name
and clicking Add . When you’re done, click Close .
You see this screen listing all registered projectors:
Note: To delete a projector from the list, highlight the
projector name, and click
Delete .
5. Click Close . You see the status of each of your registered
projectors on the main EMP Monitor screen:
Click here to start EMP Monitor
Click here
Click here
Click here