Epson 7800P - Manual (Page 17)

EPSON PowerLite 7800p Projector
16 - EPSON PowerLite 7800p Projector 5/03
Configuring the Monitoring Interval
If you need to have the most current status information about
your projectors, click the Refresh button in the EMP
Monitor screen.
You can also select how often EMP Monitor checks the
projector status:
1. From the Tool menu, select Configuration . You see this
screen.
Note: If you want EMP Monitor to run whenever you start
your computer, click
Add to Startup .
2. Select the desired update interval and click OK .
Using EMP NetworkManager
You can use EMP NetworkManager to configure the projector
to send out messages by e-mail, notifying you when a problem
occurs with the projector. Before running EMP
NetworkManager, make sure you’ve installed the software as
described in the User’s Guide. Then follow the steps below to
create e-mail settings for each projector you want to monitor.
Selecting the Projectors to Monitor
1. To start EMP NetworkManager, click Start >
Programs or All Programs > EPSON Projector >
EMP NetworkManager .
You see the EMP NetworkManager screen. The projectors
you’ve registered through EMP Monitor appear as icons.
2. If you’d like to register a projector manually and you know
its IP address, double-click the Proj(ector) address
selection icon.
You see this screen:
3. Enter the projector’s IP address and click Add . The
projector’s icon is added to the EMP NetworkManager
screen.
Setting a Password
You can set a password to restrict access to each projector from
EMP NetworkManager:
1. Right-click the icon of the projector whose password you
want to set, then select Change Password .
2. Enter a password up to 14 characters in length.
Creating the E-Mail Settings
1. If EMP NetworkManager is not already running, open it
from the Start menu. You see your registered projectors:
2. Double-click the icon for the projector whose e-mail
settings you want to create. Enter your password, if you
created one.