Stereo headphone jack, Placement of the system – Emerson Radio MS3110 User Manual

Page 14

Advertising
background image

13

Stereo Headphone Jack

This system includes a stereo PHONES jack on the back panel of the main unit.

You may connect a set of stereo headphones, not included, to this jack for private

listening without disturbing others.

The main speakers are automatically shut off when headphones are connected to

the PHONES jack. Make sure that the plug from your headphones is fully inserted

into the headphone jack. If the plug is not fully inserted the sound may be intermittent,

or you may only hear sound from one side of the headphones.

IMPORTANT: To prevent hearing damage always set the volume control to a

low level before you connect the headphones. Then connect the headphones,

put them on, and very gradually increase the volume to a comfortable listening

level. Remember that CDs may contain both very soft and very loud passages.

Adjust the volume to a comfortable level using a louder passage, so that you

always know what the maximum level will be.

Placement Of The System

The system should be placed on a stable, level surface such as a table, shelf, or

stand, convenient to a 120V 60Hz AC outlet, out of direct sunlight, and away from

sources of excess heat, dust, moisture, or vibration.

The speakers may be separated from the main as far the wires allow for maximum

stereo separation, or the may be placed to the immediate left and right of the main

unit. However to avoid interfering with the operation of the CD door the speakers

should not be placed directly against the main unit. Always leave a gap of at least

1/2 inch between the speakers and the main unit.

MS3110_112106.p65

22/11/2006, 11:48

13

Advertising