Emerson Radio MS3110 - Manual (Page 29)

28
4.) Press the OPEN/CLOSE button to close the CD door.
The display will show “TOC READ” as the player reads the Table Of Contents
on each disc. As it reads each disc the display will briefly show the total tracks
and playing time on each disc.
After reading the last disc the display will
again show the total tracks and playing
time of DISC 1. The Disc1 indicator will
flash in the display.
Note: It may take 15 to 20 seconds for the player to read the TOC of all 3
discs. The reading time may be even longer if you are using CD-RW (re-
write able) discs. This is normal and not an indication of any problem with
your unit.
5.) To play Disc 1, press the PLAY/PAUSE button or press the DISC (CD) 1
button.
To start playback with Disc 2 or Disc 3,
press the DISC (CD) 2 or DISC (CD) 3
buttons. The corresponding DISC
indicator on front panel lights up.
The Play indicator appears in the display.
6.) When playback begins, adjust the VOLUME, EQ, and X-BASS controls as
desired.
7.) Playback will continue until all tracks on all discs have been played, then the
player stops and the display shows the total tracks number and playing time on
the last disc played.
To stop playback at any time, press the STOP button.
8.) If you are finished listening, press the OPEN/CLOSE button to open the CD
door, remove your discs from the player, re-close the door and press the
STANDBY button to return the system to the Standby (Off) mode.
MS3110_112106.p65 22/11/2006, 11:48 28