HEIDENHAIN ND 760 E - Manual (Page 13)

13
Datum Setting
If you want to save the datum points in nonvolatile
memory, you must first cross over the reference
marks.
Press the datum key (“d” starts
blinking).
Datum Setting
In P70, you can select:
• Two datum points: The selected datum point
is displayed via 1 or 2
• Nine datum points: The selected datum point
is displayed in the uppermost axis via d1 to d9.
You set a datum by first pressing the corresponding axis key
and then entering a numerical value. To transfer the new
datum, press the ENT key. The CL key can be used to clear
an incorrect entry.
Enter a datum number (1 to 9).
1 ENT
Only after crossing over the reference marks can you set new
datums or activate existing ones.
To call a datum you have set, proceed as follows:
You have set two datum points in P70:
Select datum 1 or 2.
You have set nine datum points in P70:
Bateil1.pm6 21.01.2002, 09:39 13