HEIDENHAIN ND 760 E - Manual (Page 39)

40
Multipoint
A
xis
Error
Compensation
AXIS X
Select the compensation value table
(e.g., for the Z axis), and delete the table.
DELETE Z
Confirm with ENT, or cancel with CL.
Conclude entry.
Deleting a compensation-value table
Select the special functions.
PARAMETER
Select the dialog for entering the code
number.
CODE
Enter the code number 105296 and
confirm with ENT.
SPEC
FCT
Select the “parameter" function.
SPEC
FCT
or
28.024
Enter all further compensation points. If
you press the minus key, the number of
the current compensation point will be
shown in the X display. Direct selection
of compensation
points: Press the minus key together
with the number (two-digit) of the
desired compensation point.
Conclude entry. or
Bateil2.pm6 27.03.2002, 12:04 40