HEIDENHAIN ND 1200T - Manual (Page 49)

Tool-Chek ® TC200
2-23
Step 2
Align the first line of the angle with the crosshairs on the tool
presetter and press enter. The location of the targeted point will
be shown on the Probe Line 1 screen and the number of points
indicated on the lower left part of the display will increase. A
minimum of 2 points is needed for a line. When all points are
entered press the Finish command key.
Step 3
Align the second line of the angle with the crosshairs on the tool
presetter and press enter. The location of the targeted point will
be shown on the Probe Line 2 screen and the number of points
indicated on the lower left part of the display will increase. A
minimum of 2 points is needed for a line. When all points are
entered press the Finish command key.