HEIDENHAIN CNC Pilot 4290 Description of the Y axis - Manual (Page 43)

HEIDENHAIN CNC PILOT 4290 43
Surface window
The contour display and traverse-path display in the
surface window are oriented to the position on the
”unrolled” lateral surface (designation: CY) and the
Z coordinates.
3
Y
Axis
in
Simulation
Front window
In the front window, the contour and traverse paths
are shown in the XY plane, taking the spindle
position into account. The spindle position 0° is
located on the positive X axis (designation: ”XK”).
”Side view (YZ)” window
In the ”side view” window, contour and traverse
paths are shown in the YZ plane. The side view
depicts only the Y and Z coordinates – not the
spindle position.
Y_4290BH.pm6 08.03.2005, 08:36 43