HEIDENHAIN CNC Pilot 4290 Description of the Y axis - Manual (Page 57)

HEIDENHAIN CNC PILOT 4290 57
Linear hole pattern, linear figure pattern
You can define the starting point of the pattern in Cartesian
coordinates. You can use several parameter combinations to define
the individual hole/pattern positions.
The pattern positions define the center of the hole/figure. For
circular slots, the pattern positions define the center of curvature.
Parameters
Y, Z: Starting point of pattern
Q: Number of holes/figures
YE(J), ZE(K): End point of pattern
Yi(Ji), Zi(Ki): Distance between holes/figures in the Y and Z
directions
L(R): Distance from first to last hole/figure
Li(Ri): Distance between holes/figures
β (A): Angle of longitudinal axis of pattern (reference: positive Z
axis)
Hole description/figure description
4.1.3
Contours
in
the
YZ
Plane
(Side
View)
Circular slot
Parameters
YM(Y), ZM(Z): Center of curvature
A:
Starting angle (beginning of slot)
β (W): End angle (end of slot)
R: Radius of curvature
B: Width of slot
P: Depth of pocket
Y_4290BH.pm6 08.03.2005, 08:37 57