HEIDENHAIN TNC 320 (340 55x-05) Cycle programming - Manual (Page 367)

HEIDENHAIN TNC 320 367
16.1 F
undamentals
Recording the results of measurement
For all cycles in which you automatically measure workpieces (with
the exception of Cycles 0 and 1), you can have the TNC record the
measurement results. In the respective probing cycle you can define
if the TNC is to
„ Save the measuring log to a file
„ Interrupt program run and display the measuring log on the screen
„ Create no measuring log
If you want to save the measuring log to a file, the TNC, by default,
saves the data as an ASCII file in the directory TNC:\..
430 MEASURE BOLT HOLE CIRCLE
(2nd soft-key row) Measuring position
and diameter of a bolt hole circle Page 403
431 MEASURE PLANE (2nd soft-key
row) Measuring the A and B axis angles
of a plane Page 407
Cycle Soft key Page
Use the HEIDENHAIN data transfer software TNCremo if
you wish to output the measuring log via the data
interface.