HEIDENHAIN TNC 320 (340 55x-05) Cycle programming - Manual (Page 416)

416 Touch Probe Cycles: Special Functions
1
7.1 F
undamentals
17.1 Fundamentals
Overview
The TNC provides a cycle for the following special purpose:
When running touch probe cycles, Cycle 8 MIRROR
IMAGE, Cycle 11 SCALING and Cycle 26 AXIS-SPECIFIC
SCALING must not be active.
HEIDENHAIN only gives warranty for the function of the
probing cycles if HEIDENHAIN touch probes are used.
The TNC must be specially prepared by the machine tool
builder for the use of a 3-D touch probe.
Cycle Soft key Page
3 MEASURING Cycle for defining OEM
cycles Page 417