HEIDENHAIN iTNC 530 (340 49x-03) - Manual (Page 19)

HEIDENHAIN iTNC 530 19
1.1 The iTNC 530 ..... 46
Programming: HEIDENHAIN conversational, smarT.NC and ISO formats ..... 46
Compatibility ..... 46
1.2 Visual Display Unit and Operating Panel ..... 47
Visual display unit ..... 47
Screen layout ..... 47
Operating panel ..... 48
1.3 Modes of Operation ..... 49
Manual operation and electronic handwheel ..... 49
Positioning with Manual Data Input (MDI) ..... 49
Programming and editing ..... 50
Test Run ..... 50
Program Run, Full Sequence and Program Run, Single Block ..... 51
1.4 Status Displays ..... 52
“General” status display ..... 52
Additional status displays ..... 54
1.5 Accessories: HEIDENHAIN 3-D Touch Probes and Electronic Handwheels ..... 61
3-D touch probes ..... 61
HR electronic handwheels ..... 62
1 Introduction ..... 45