Center line as preset – HEIDENHAIN iTNC 530 (60642x-04) User Manual
Page 613
HEIDENHAIN iTNC 530
613
14.9 W
or
k
piece pr
eset
ting with a t
o
uc
h pr
obe
Center line as preset
Select the probe function: Press the PROBING soft
key
Position the touch probe at a position near the first
touch point
Select the probing direction by soft key
Start the probing procedure: Press the NC Start button
Position the touch probe at a position near the second
touch point
Start the probing procedure: Press the NC Start button
Datum:
Enter the coordinate of the preset in the menu
window, confirm with the SET DATUM soft key, or
write the value to a table (see "Writing the measured
values from touch probe cycles to datum tables",
page 598, or see "Writing the measured values from
touch probe cycles in the preset table", page 599, or
see "Storing measured values in the pallet preset
To terminate the probe function, press the END key
X
Y
X+
X
X
Y
X
X+